![]() This cable do not support the 187.5 Kbps baud rate as the same with the Siemens PC / PPI programming cable which with the RS232 interfaces. Quit the software and plug a USB plug or re-install the USB driver. If the COM port in the programming software with "*" symbols, such as "* COM3", it’s shown that the COM port have faults. Here are requested to indicate that "USB" option in the local communications interface setting which the software is not support to the programming cable. And the following steps are exactly the same as in the traditional programming cables with RS232 interfaces. The step next is just to choose this COM port in the programming software and other application software and keep other communication parameters as in the Default settings. And for the specific installation steps, please refer to the instruction files on the CD-ROM drivers, and details are not necessarily listed here.Īfter completing Driver installation, the corresponding COM port for the USB/PPI programming cable will be displayed in the “Device Manager” of Window. ![]() USB device drivers should be installed before using USB/MPI+ programming cable, which are available on the CD-ROM sold together with the cable. Each PC only supports one USB cable programming.Support long-distance communications, the largest communications is two kilometers (9600 bps).Support UART data format: data bits: 7-8 stop bit: 1, 2 check-bit: odd / even / no parity. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |